Bedec Aqua Advanced High Gloss Paint
Bedec Aqua Advanced High Gloss Paint is a trade quality water-based acrylic polyurethane enamel that is ideal for interior and exterior use.
A high performance interior and exterior gloss acrylic paint, specially formulated for adhesion, durability, and water resistance. It is the perfect topcoat for use over Bedec Aqua Advanced Primer Undercoat. The gloss finish on woodwork helps to hide imperfections and gives colour a striking appearance and is perfect for application to doors, skirting boards, windowsills, door frames and wooden window frames.
Key Information
| Brand | Bedec |
|---|---|
| Coverage | 13–15m² per litre (depending on substrate and porosity) |
| Application | Brush, Roller, Spray |
| Drying Time | Touch dry in 30 minutes; dry to recoat in 4 hours @ 23°C |
| Coats | 2 coats |
| Cleanup | Clean directly after using water |
| Storage | 2 years if can kept dry and firmly shut, away from direct sunlight |
| VOC | 130g/l |
| Material | Waterbased acrylic |
| MPN | QA0002, QA0003 |
Documents
Product Information (68kb PDF)
Safety Data Sheet (134kb PDF)
Bedec Product Range (1.1Mb PDF)
Preparation
Ensure surfaces to be painted are clean dry and free from dust, dirt, grease and wax. We recommend using the Rodo Poly Sheet Dust Roll. Remove all loose and defective paint. For further information contact customer care.
Algae and fungal growths should be treated with fungicidal wash and removed. Allow new galvanised at least one month to weather before painting. Areas under constant water contact such as showers (hot and cold) aren’t recommended for Bedec Aqua-Advanced High Gloss.
Application
Ensure temperature is above 8°C during application and drying. Do not apply when foggy or damp or likely to rain before the paint has dried.
Brush — For best results use a good quality synthetic (nylon or polyester) brush, designed for water based products such as the Wooster Ultra/Pro Firm brush.
Roller — Mini rollers are very good for flush doors, radiators etc.
Airless Spray — Make sure the Tip size 13–17 thou, Pressure 2000–2500 psi.
Conventional Air Spray or HVLP — recommend a 1.8mm needle nozzle set up.
Aftercare
Fully hardened after one week.
Clean equipment immediately after use with warm soapy water. Remove as much product as possible prior to cleaning.
Do not empty in to drains or watercourses. Some local authorities have special facilities for disposal or dispensing of waste coatings.
Product Numbers
Manufacturer's Part Numbers (MPN):
QA0002/1, QA0002/2.5, QA0002/5, QA0003/1, QA0003/2.5
