eicó Alterior Gloss
A Traditional Hard-wearing Gloss that Dries to a Beautiful High Sheen Finish.
A versatile high quality waterborne paint that dries to a non-yellowing Gloss finish. Holds excellent colour retention. Low dirt pick-up, good weathering properties and washability. Adheres well with outstanding coverage. Ideal for use in bathrooms and in the food industry (where resistance against humidity is required). Very little odour, solvent free with low VOC rating (VOC < 2.5%). Max. VOC content - 36g/litre.
Areas of Use
Interior and Exterior: Walls, Ceilings, Roof Tiles, Front Doors
Substrates: Concrete, Masonry, Cements, Rendering Plaster, Plaster Board, Lining Paper, Glass Fibre, Woodwork, Primed Steel etc.
- Suitable for interior and exterior use
- Perfect for application on front doors
- Reflective high Sheen finish with high durability
- Ready to use brush or roller use
- Beautiful streak free
- 100% pure Acrylics
|Use||Ideal for FRONT DOORS & BATHROOMS.|
|Drying Time||2-3 hours touch dry|
|Recoating time||Min. 8 - 10 hours|
|Colours||eicó range or we can tint to any colour desired. Contact us for details or call 0333 208570.|
The surface should be stable, firm, dry and free of contaminants (dust, sand, loose old paint, dirt etc.). On rough surfaces it may be necessary to dilute the paint by about 10% with fresh water. Use only where application and drying can proceed at temperatures above 7°C, preferably above 10°C. Ensure relative humidity is below 80%.
One or Two coats can be applied to achieve the desired coverage and colour depth. The best results are achieved between 18°C and 22°C with good air movement and ventilation.
Where required apply ican Grepp Primer to improve paint adhesion. Use a fine-tipped Synthetic Bristle Brush to apply the paint in a vertical direction then spread the paint out evenly in a horizontal direction. The perfect brush for this job is the Purdy Syntox brush which is designed for an ultra smooth, mirror-like finish on wood. Lay off the final coat in one direction to eliminate brush.
When using Roller application, use a medium pile woven polyester roller. Apply the paint in sloping strokes to spread the paint consistently. Repeat this action by operating in small sections. Always dry to wet areas to minimise roller marks. Lay the final coat in a single direction to ensure that any roller marks are minimised.
When Airless Spraying set up of 18 thou (457µm) 65° angle tip using a pressure of between 2000–2700 psi (138–186 bar) for good results.
When HVLP Spraying the paint may need to be diluted with water by up to 10%. Trial with the air control valve, material flow adjustment, fan size and spray pattern settings on a discreet area until you are happy with the finish. Spray several thin coats, allowing each coat to dry fully before applying the next one.