Bedec Aqua Advanced High Obliterating Matt
The high build white paint that will cover everything
Bedec Aqua Advanced High Obliterating Matt is a high performance interior matt acrylic paint specially formulated for adhesion, durability, and water resistance. It is the perfect product for interior block work and obliterating deep colours.
Bedec Aqua Advanced High Obliterating Matt is a high-build, high obliterating, water-based, matt finish suitable for use on internal walls and ceilings. It is quick drying, non-yellowing, has excellent flow, low odour and is high build. It does what it says on the tin and completely obliterates previous paint, marks, wallpaper and other marks on surfaces.
Bedec Aqua Advanced High Obliterating Matt is also designed to infill block and brickwork to give a smoother surface where the cost of rendering and plastering is not required. Giving one coat coverage in most instances for high usage areas such as hallways, warehouses, stockrooms and factories over suitably prepared surfaces
- Quick drying
- Non yellowing
- Excellent flow
- Low odour
- High build
|Coverage||6–10m² per litre (depending on substrate and porosity)|
|Application||Brush, Roller, Spray|
|Drying Time||Touch dry in 60 minutes; dry to recoat in 4 hours @ 23°C|
|Coats||1 coat in most cases|
|Cleanup||Clean directly after using water|
|Storage||2 years if can kept dry and firmly shut, away from direct sunlight|
Ensure surfaces to be painted are clean dry and free from dust, dirt, grease and wax. Remove all loose and defective paint. For further information contact customer care.
Algae and fungal growths should be treated with fungicidal wash and removed. Allow new galvanised at least one month to weather before painting. Areas under constant water contact such as showers (hot and cold) aren’t recommended for Bedec Aqua-Advanced High Obliterating Matt.
Ensure temperature is above 8°C during application and drying. Do not apply when foggy or damp or likely to rain before the paint has dried.
Brush — For best results use a good quality synthetic (nylon or polyester) brush, designed for water based products such as the Purdy Syntox.
Roller — Mini rollers are very good for flush doors, radiators etc.
Airless Spray — Make sure the Tip size 13–17 thou, Pressure 2000–2500 psi.
Conventional Air Spray or HVLP — recommend a 1.8mm needle nozzle set up
Fully hardened after one week.
Clean equipment immediately after use with warm soapy water. Remove as much product as possible prior to cleaning.
Do not empty in to drains or watercourses. Some local authorities have special facilities for disposal or dispensing of waste coatings.
Manufacturer's Part Numbers (MPN):