Bona Craft Oil 2K

Bona Craft Oil 2K is a professional high performance two-component base oil for wooden floors.

Bona Craft Oil 2K is designed for versatility and maximum performance. It gives the natural rich look and feel of an oiled floor, plus the added protection of a lacquer.

Bona Craft Oil 2K’s unique formula, made from modified plantbased oil, delivers an accelerated drying time and great wear resistance. It's the perfect treatment for a wide variety of wood species including tricky ones such as cherry and walnut. It produces a beautiful strong water and stain-resistant surface that is ready for light use in just 8 hours.

Performance, versatility and design – Bona Craft Oil 2K can be used on its own as a quick drying, high-performance oil or be combined with a lacquer for different gloss levels and a practically maintenance free surface. The unique formula is made from modified plant-based oil and delivers tough, water and stain resistant protection to floors in domestic or medium wear environments - even before the application of a lacquer coat. Light use is possible in as little as 8 hours.

Areas of Use

Bona Craft Oil 2K is compatible with most wood species, even hardwoods such as cherry, walnut, smoked oak and steamed beech and available in Neutral.

Technical Information

Documentation

Safety Data Sheet (139kb PDF)

Preparation

Prior to application the surface must be pre-treated with a waterborne primer from Bona. For Bona Mega we recommend Bona Classic, Bona Natural, Bona Amber or Bona Intense. Ensure floor is acclimatized to its end-use environment, well sanded, dry and free from sanding dust, oil, wax and other contamination. Allow lacquer to reach room temperature, insert filter and shake the container thoroughly before use.

Optimal application conditions are between 18–25°C and 30–60% relative air humidity. High temperatures and low humidity shorten, low temperatures and high humidity lengthen drying time. Minimum temperature for use is 13°C.

Application

Apply the lacquer using a Bona Roller. Roll with a smooth flowing motion alternately across and with the grain of the wood avoiding accumulations of product. Always maintain a “wet edge” to avoid overlaps. Allow to dry before applying further layers of lacquer. Anticipate slightly longer drying time for each layer that is applied.

If necessary make an intermediate sanding using a screen or the Bona Scrad System grit P150 (or finer) and remove dust before applying the final layer of lacquer.

Note: If the previous layer of lacquer has been allowed more than 24 hours drying time then an intermediate sanding is always required.

The floor will take light foot traffic approximately 8 hours after the final application. Allow the surface to dry for at least 1 week before covering with carpets or other floor coverings, or loading with heavy objects. Also avoid damp mopping the floor during this time.

Aftercare

Clean the floor with Bona Cleaner or Bona Wood Floor Cleaner and a microfibre pad. For maintenance and upkeep of the surface, floors can be overcoated at intervals with additional coats of lacquer. The frequency of this operation can be greatly reduced if Bona Freshen Up or Bona Wood Floor Refresher is applied periodically. This will restore the appearance of a dull floor whilst still allowing further coats of lacquer to be applied without the need for sanding the floor back to bare timber.