Bedec All Prime
PRODUCTS RELATED TO THIS ITEM
ALL SURFACE ALL PURPOSE WHITE and GREY PRIMER.
Bedec All Prime is an all-purpose primer, designed for interior and exterior walls, ceilings, doors, trim, fascia, soffits, foundations, railings, ferrous, non-ferrous metals and pretty much all related paintable surfaces.
It really does everything. It has been engineered to even out the porosity of a range of surface and ensure optimum adhesion between your topcoat and surface, providing you with the best possible results from your paint system and giving you a finish that endures.
Some stains may require a second coat. For best results, allow to dry overnight before applying topcoat. Very porous woods may require two coats before the topcoat.
FAQ
How do I prepare the surface before application?
The surface should be clean, dry, sound and free of dust, dirt, excessive chalky material, grime, oil, wax, mould, wallpaper adhesive or any contamination that may interfere with adhesion of the paint to the surface.
If unsure, always wash the surface with the appropriate cleaning solution such as Koate Soap or methylated spirits and rinse off. Clean new galvanized with methylated spirits.
Remove any unsound coatings with a scraper. Sand any remaining paint film edges smooth and level with the new surface with a sia abrasive (320-400 grit).
New plaster which is polished or dusty should be abraded to open the surface. Lightly sand exposed wood with 80 to 100 grit sandpaper to remove loose or weathered wood fibres.
When priming over stained areas, first attempt to remove as much of the stain as possible by washing, sanding, scraping etc.
Remove mould and treat area with a fungicidal wash. Remove rust/wire brush rusty areas and wipe with methylated spirits. Spot prime knots and sap streaks after suitable preparation
Glossy surfaces - Adheres to glossy enamel paints and clear finishes, contiboard MDF, PVC, fibreglass, vinyl, ceramic wall tiles. Pre-sanding or surface de-glossing may be needed.
What is the best way to apply the product?
Stir well before using. Apply when the air and surface temperature is above 5°C and relative humidity is less than 85%. This product can be applied with a brush, roller or spray gun.
Spraying – Depending upon equipment Airless Spray – 2500 psi 13 to 15 thou tip, 50° Angle, HVLP – up to 15% clean water 15 to 18 thou tip. Ready to use – no dilution necessary unless on porous surfaces where a thinned down priming coat (up to 30%) with clean water is required.
What is the drying time?
At 18°C and 65% relative humidity dry to touch in 2 hours, re-coatable after 4 hours. Topcoat within 30 days. Full adhesion and hardness develop in 7 days.
What is the coverage?
10m² per litre. Coverage may vary with surface porosity.
How Do I Clean up After?
Clean application tools with warm water and liquid detergent. Dispose of unused or unwanted product in accordance with local laws regulating water-based coatings.
