eicó Flat Eggshell Paint

FLAT EGGSHELL IS A SUPERB PAINT FOR INTERIOR WOODWORK AND METAL. DRIES TO A SMOOTH LOW SHEEN.

eicó Flat Eggshell is a high-quality waterborne enamel paint that dries to a non-yellowing flat Eggshell finish. Gives the surface high resistance and hardness, and is therefore perfect for interior walls, ceilings and radiators. The washable low sheen finish is also the ideal paint for kitchens, bathrooms and conservatories. Low dirt pick-up, outstanding weathering properties and solvent-free.

Click here to view an online eicó colour chart

Areas of Use

Interior: Walls, Ceilings, Primed Wooden and Metal Surfaces

Substrates: Wood, Metal, Concrete, Cement, Rendered Plaster, Plasterboard, Lining Paper, Glass Fibre, Particleboard

eicó Flat Eggshell Paint is

• Designed for interior use on Wood, Metal and Plasterboard
• Perfect for painting interior doors, skirting boards, door frames, bannisters and radiators
• Available in the eicó contemporary colour assortment or can be tinted to any colour
• Ready to use - brush or roller use
• Low odour
• Beautiful streak free 
• High opacity 100% Pure Acrylic paint

Technical Information

Documentation

Technical Data Sheet

Preparation

On rough surfaces it may be necessary to dilute the paint by about 10% with fresh water. Use only where application and drying can proceed at temperatures above 5ºC, preferably above 10ºC and relative humidity below 85%. Temperature of surface should be 5 to 35º C.

The surface should be stable, firm and free of dust, sand, loose old paint, laitance, dirt, grease and oil prior to using to avoid problems such as uneven or patchy drying. Prime the surface with a suitable water based primer like ican Grepp V.

Surfaces should be cleaned down to remove surface contaminants prior to applying.

Before using the paint, it should be thoroughly mixed. Shaking the container will ensure possible all pigment in the paint is dissolved.

Ensure you check the colour by conducting a test area to ensure the finished colour is suitable. 

Application

One or Two coats can be applied to achieve the desired coverage and colour depth. The best results are achieved between 18°C and 22°C with good air movement and ventilation.

Use a fine-tipped Synthetic Bristle Brush to apply the paint in a vertical direction then spread the paint out evenly in a horizontal direction. Lay off the final coat in one direction to eliminate brush marks.

When using Roller application, use a medium pile woven polyester roller. Apply the paint in sloping strokes to spread the paint consistently. Repeat this action by operating in small sections. Always dry to wet areas to minimise roller marks. Lay the final coat in a single direction to ensure that any roller marks are minimised.

When Airless Spraying set up of 18 thou (457µm) 65° angle tip using a pressure of between 2000–2700 psi (138–186 bar) for good results.

When HVLP Spraying the paint may need to be diluted with water by up to 10%. Trial with the air control valve, material flow adjustment, fan size and spray pattern settings on a discreet area until you are happy with the finish. Spray several thin coats, allowing each coat to dry fully before applying the next one.

Aftercare

Wipe lightly with a soft damp cloth or sponge.

Clean brushes and rollers with warm soapy water.