The Purdy roller that loads and releases more paint to deliver a superior & smooth finish.
The large core diameter holds 25-35% more paint which significantly helps to increase production. Use with all paints and exterior stains, particularly if you desire a smooth, lint free finish. The White Dove series features a high density woven cover which enables the paint to flow freely into and out of the cover, as well as a tapered end to decrease tramlines. This results in both easy rolling and a high quality finish.
Get the look
Areas of Use
Application: Drywall, Ceilings & Floors, Latex-based paints, Oil-based paints, Semi-Transparent stains, Water-based urethanes
Paint Finish: Very Smooth to Semi Rough Surfaces
Features
- Holds 25-35% More paint than cheap alternatives
- Built with the best quality fabrics
- Same quality as the brushes
- Load paint well and release evenly
- Produces the smoothest finish on walled surfaces
Technical Information
| Brand | Purdy |
|---|---|
| Nap Size | 3/8" and 1/2" |
| Core Material | Polypropylene |
| Fabric Material | Woven Dralon Fabric |
Preparation
Investing in a good quality roller sleeve is a must. Cheaper covers tend to not hold enough paint and increase the time it takes to do a good job. Use a 3/8 inch (1 cm) nap for flat paint on walls and ceilings, 1 inch (2.5 cm) nap for rough surfaces like textured ceilings, and ¼ inch (.63 cm) nap for satin or semi-gloss paint.
It is essential to pick the correct roller sleeve for the type of paint and substrate you are painting. We recommend the following:
- Purdy White Dove for leaving a perfectly smooth, lint free finish ideal for domestic jobs.
- Purdy Marathon for where versatility and a quality appearance is desired.
- Purdy Colossus for larger jobs where productivity is essential.
Ensure you brush around the edges first, as rollers cannot get tight to edge. The first painting step is to brush along the ceiling, inside corners and mouldings.
Application
Start with the top half of the wall, so that drips fall on unpainted areas. Dip the roller about halfway into the paint. Run the roller along the grid until the sleeve is nicely saturated but not dripping.
Work in small zones of two to three square feet at a time. Listen to the roller. It should sound wet. When the roller loses that crinkly, moist sound, it’s time to load it up with more paint.
Paint a stripe up the wall, bottom to top. At the top, turn the roller sideways, then zigzag it back down. Repeat these steps across the length of the wall, with each new stripe overlapping a three-inch portion of the area already painted. For all types of rooms, most experts recommend two to three coats.
Aftercare
Scrape excess paint from the roller before you wash it. Use your putty knife, or better yet, a special roller-scraping tool with a semi-circular cut-out in the blade. A Purdy 6-in-1 tool is perfect for this task.
Wash the roller with warm water and detergent. Lather up the roller and scrub the mat with your fingers. The detergent will pull a lot of the paint residue out of the mat and make the next step easier. Rinse the roller cover until the water runs clear.