TECHNICAL INFORMATION

Documents

Tech Data Sheet

Product Catalogue

Preparation

Perfect sanding is a must for a clean and attractive surface finish. Please see the technical data sheet for the recommended sanding sequences for the surface you are treating. Vacuum clean thoroughly, remove any remaining dust with Rubio Monocoat Cleaner.

A trial application of Rubio Monocoat Oil Plus 2C is recommended on a small section of the substrate before commencing.

How do I apply Rubio Monocoat Oil Plus 2C?

Oils enhance the natural tone of wood. Applying the product too generously and with insufficient ventilation will lead to delays in drying.

If using both components, carefully mix the two components (1 to 2 min) with a ratio of approximately 3:1 of Part A to Part B.

Once the cleaned surface is dry, spread out a small quantity of Rubio Monocoat Oil Plus 2C with a cloth or scrub pad - we recommend Rubio Monocoat's specially designed Scrubby Set, which helps the oil penetrate the wood fibres for long-lasting and even coverage. Work in zones of 5–10 m².

Let the oil absorb for a few minutes. Thoroughly remove all excess of oil with a clean cloth within 15 minutes per zone. The surface should feel dry! Finish all zones the same way.

After 24–36 hours the surface can be used.

Aftercare

Wooden surfaces treated with Rubio Monocoat Oil Plus 2C are very easy to maintain.

Remove coarse dirt with a broom or a vacuum cleaner. To clean, add Rubio Monocoat Natural Soap to water and clean the surface with a damp mop or cloth.

To refresh and clean intensively, we highly recommend:

• Rubio Monocoat Grease Remover to remove stubborn grease stains
• Rubio Monocoat Lime Spot Remover for stains caused by water rings, radiator leaks, urine, or other hard water stains 
• Rubio Monocoat Tannin Remover for rings from metal/cans, moisture spots, and acid spots

For general maintenance or to refresh the look of the original oil, we highly recommend:

• Rubio Monocoat Universal Maintenance Oil
• Rubio Monocoat Surface Care