The performance 2K epoxy mastic for repair and maintenance in cold conditions.
Jotamastic 87 Winter Grade is a two-pack, high solids, high build, anticorrosive, surface-tolerant, epoxy mastic coating with abrasion resistance qualities for repair and maintenance. It is ideal for use on steel where blast cleaning may not be possible, surfaces that are still moist and as a solution for less severe environments. Comes with an Activator designed for spraying in low temperatures.
Area of Use
Jotamastic 87 Winter Grade is specially designed to aid application in lower temperatures and provide significantly faster dry and cure times. Product is suitable for exterior metal surfaces and is ideal for a wide range of industrial structures:
Marine: Outside hull, exterior and interior areas, including water ballast tanks (approved for PSPC for water ballast tanks according to IMO Res. MSC 82/W)
Protective: Recommended for offshore environments, including splash zones, refineries, power plants, bridges, buildings, mining equipment and general structural steel
Substrate suitability: Carbon steel, galvanized steel, stainless steel, aluminium, concrete and a range of aged coating surfaces
Perfect for use in atmospheric and immersed environments - can be applied at sub zero temperatures. Excellent protection against salt and fresh water. Chalking can occur if finish is exposed to sunlight.
- This product is part of the Network Rail/Railtrack RT98 System M21
- Certificate numbers XM92/M21 and XM92/M21-147
- Low Flame Spread in accordance with EU Directive for Marine Equipment. Approved in accordance with parts 5 and 2 of Annex 1 of IMO 2010 FTP Code, or Parts 5 and 2 of Annex 1 of IMO FTPC when in compliance with IMO 2010 FTP Code Ch. 8
- Certified for London Underground use under No. 538 - Surface Tolerant Paint System: Jotamastic 87 Aluminium and Hardtop XP
Polyamine cured epoxy mastic coating
|Coverage||Approximately 3 - 5.5m2 per litre|
|Stock Colours||Small colour range|
|Application||Airless Spray, Brush or Roller|
|Drying Time||Touch dry in 18 hours, Dry to recoat 24 hours, Fully cured in 7 days @ 10°C|
|Mix Ratio||6:1 with Jotamastic 87 WG Comp B|
|Wet Film Thickness (WFT)||
200 - 340 μm
|Dry Film Thickness (DFT)||
150 - 250 μm
|Cleaner/Thinner||Clean directly after using Jotun Thinner No. 17|
|Storage||36 months if can kept dry and firmly shut, away from direct sunlight|
We take health and safety seriously here at AllFinishes and recommend you use the correct protection for the job. Disregarding safety equipment can be damaging and result in long term health conditions. Please check out our Moldex range for high quality respirators and hearing protection.
To secure lasting adhesion to the subsequent product all surfaces shall be clean, dry and free from any contamination.
|Coated surfaces||Clean, dry and undamaged compatible
coating (ISO 12944-5 6.1)
|Clean, dry and undamaged compatible
coating (ISO 12944-5 6.1)
|Carbon steel||St 2 (ISO 8501-1)||St 2 (ISO 8501-1)|
|Shop Primed Steel||Clean, dry and undamaged shop
primer (ISO 12944-5 6.1)
|Sa 2 (ISO 8501-1)|
It is strongly advised to apply Jotamastic 87 Winter Grade with an airless spray, using only brush and roller application for small areas (or stripe coatings). Roller application is not recommended for a first primer coat - see the application guide for further information. If applied at the correct film thickness to proeprly prepared steel, it is able to prevent corrosion for up to 15 years.