Bona Traffic Natural Delivers superior protection whilst preserving the look and feel of pure, untreated wood.
Bona Traffic Natural is a high quality 2 component waterborne polyurethane topcoat lacquer which offers superior protection for commercial and public areas. For a truly natural looking surface, combine Bona Traffic natural with Bona Natural Primer.
- Non-yellowing properties.
- GreenGuard approved product for low indoor emissions
- Easy to apply and safe to use.
- High quality protection for high traffic areas and commercial use.
- Protects and preserves the look and feel of pure wood.
|Coverage||Approx 8–10m2 per litre|
|Drying Time||Touch dry and ready to recoat in 2.5–3.5 hours @ 20°C. Light use in 24 hours|
|Coats||1 coat of Bona Natural Primer, then 2 coats of Bona Traffic Natural|
|Cleanup||Clean directly after using water|
|Storage||1 Year if can kept dry and firmly shut and away from direct sunlight|
Safety Data Sheet (139kb PDF)
Bona Traffic has in general very good adhesion to factory pre-finished and previously lacquered floors but the surface must be carefully cleaned and abraded prior to overcoating. See separate guideline for overcoating recommendations.
Shake the Traffic Natural can and add one bottle of Traffic Hardener. Immediately shake the mixture thoroughly for 1 minute and then insert the enclosed filter. If mixing smaller quantities of lacquer then pour the required amount of lacquer into a separate can. 1 litre of lacquer corresponds to one part of hardener. 2 litres to two parts a.s.o. The mixture of lacquer/hardener should be used directly or at least within 4 hours
Apply Bona Traffic Natural using a Bona Roller. Roll with a smooth flowing motion alternately across and with the grain of the wood avoiding accumulations of product. Always maintain a “wet edge” to avoid overlaps. Allow to dry properly before applying further layers. Anticipate slightly longer drying time for each layer that is applied.
If necessary make an intermediate sanding using a screen or the Bona Scrad System grit P150 (or finer) and remove dust before applying a final layer of lacquer. Note: If the previous layer of lacquer has been allowed more than 24 hours drying time then an intermediate sanding is always required.
Floor will take light foot traffic approximately 8 hours after the final application. Allow the surface to dry for at least 1 week before covering with carpets or other floor coverings, or loading with heavy objects. Also avoid damp mopping the floor during this time.
Clean the floor with Bona Cleaner or Bona Wood Floor Cleaner and a microfibre pad. For public areas it may be necessary to introduce a machine based cleaning programme. Worn surfaces can be renewed by applying a new layer of Bona Traffic Natural after firstly cleaning and superficially abrading the surface. See separate guideline for overcoating instructions.