Bedec Extra Flex Masonry Paint (Special Colour)
Flexible, Long-lasting, Smooth Satin Finish for Masonry in any Color Desired
Bedec Extra-Flex Elastomeric Masonry Paint is a high performance flexible masonry paint. It is for exterior application and has outstanding flexibility and weather resistance. It can be used for the protection of exterior masonry, cladding, pebbledash, bricks and mortar, cement and concrete rendered exteriors.
Allfinishes are proud to offer Bedec's superb Extra-Flex Masonry Paint in any colour desired. Use our colour picker to select the colour from the range you want.
Please note this product will take 5 working days to turn around.
Bedec Extra-Flex Masonry paint is a water-based, quick drying, modified acrylic blend that is a flexible microporous protective coating. It is perfectly suited for the protection of exterior masonry surfaces.
Bedec Extra-Flex Masonry paint will flex with the substrate where movement causes cracking in conventional masonry paint. It has the ability to Stretch up to 400% of its original dry state and the elastic properties ensure you will have a smooth, flexible and long lasting finish to your exterior surfaces. It is also Microporous meaning it allows the substrate to breathe easily over its lifecycle.
Bedec Extra-Flex Masonry can be applied to previously painted surfaces after suitable preparation. It is suitable for masonry, roughcast, pebbledash, brickwork, cement and concrete rendered surfaces.
- Stretches up to 400%
- Smooth finish
- Long lasting
- Fine crack bridging
|Coverage||10m² per litre (depending on substrate and porosity)|
|Application||Brush, Roller, Spray|
|Drying Time||Touch dry in 2; dry to recoat in 4 hours @ 23°C|
|Cleanup||Clean directly after using water|
|Storage||2 years if can kept dry and firmly shut, away from direct sunlight|
|MPN||MB0002, MB0003, MB0415, MB0556, MB0773, MB1864, MB1910, MB1911, MBE004, MBH003, MBK004|
We take health and safety seriously here at AllFinishes and recommend you use the correct protection for the job. Disregarding safety equipment can be damaging and result in long term health conditions. Please check out our Moldex range for high quality respirators and hearing protection.
Treat mould and mildew with Fungicidal Wash. Remove all loose, flaky or powdery residues. Porous surfaces should be treated with Stabilising Solution, allowing at least 12 hours drying before coating. Common Fletton Bricks must be dry, and should be treated as porous.
Stir thoroughly and check colour before use.
Apply by brush roller or spray (use HVLP or Airless spray for best results). We recommend using the Rodo Flat Masonry Brush.
Do not apply at temperatures below 10°C or when foggy or likely to rain before the paint has dried. Two coats are recommended for optimum durability. Ensure adequate ventilation during application and drying.
Clean equipment immediately after use with warm soapy water. Remove as much product as possible prior to cleaning.
Manufacturer's Part Numbers (MPN):